|Page 1 of 1|
|Author:||telcoman95 [ Thu Jun 18, 2015 10:19 am ]|
|Post subject:||Gauntlet Wiring|
I am building a gauntlet for our club due to some physical space restraints. The issue is we will be going through the section in one direction into another room making a large loop. On the return route the polarity through the gauntlet is opposite in this direction (like a reversing section). We are trying to avoid any AR's on our layout. With this is mind I need to gap the PCB ties between the rails on each side instead of in the middle as shown on the drawings. That isn't a problem as I see it as long as I be very careful making the isolation gaps. My question is do I still place the gap the same way on the frogs? Do you see any issues gapping between the parallel rails on each side?
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group