Fast Tracks
http://fast-tracks.net/forums/

I would like Fast Track Curved Turnouts on my XTrkCad layout
http://fast-tracks.net/forums/viewtopic.php?f=6&t=1142
Page 1 of 1

Author:  rziebol [ Thu Nov 18, 2010 11:59 pm ]
Post subject:  I would like Fast Track Curved Turnouts on my XTrkCad layout

I am attempting to design my layout using XTrkCad. XTrkCad already has a lot of the fast track turnouts available. What they don't have yet is the curved turnouts as they recently were made available from Fast Tracks.

I would like to use the Turnout Designer available within XTrkCad to configure and put curved turnouts on my layout.

The problem is I don't have all the measurements needed to establish them within XTrkCad.

I have attached a snapshot of the measurements that I need to setup the curved turnouts within XTrkCad to this posting.

If someone at Fast Tracks could provide the measurements for the different curved turnouts provided, that would be really great. I would then establish them in a file and post them on the Yahoo discussion board for XTrkCad so everyone can use them on their layout designs.

Rodney

Attachments:
File comment: Snapshot of the XTrkCad Software for measurements required to establish a curved turnout.
11-18-2010 7-50-55 PM.png
11-18-2010 7-50-55 PM.png [ 9.49 KiB | Viewed 7746 times ]

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/