Fast Tracks http://fast-tracks.net/forums/ |
|
question about the "hex and single juicer?" http://fast-tracks.net/forums/viewtopic.php?f=5&t=1130 |
Page 1 of 1 |
Author: | Chesticus [ Thu Jul 29, 2010 9:39 pm ] |
Post subject: | question about the "hex and single juicer?" |
Sorry if this has been posted before. 1)Can the hex frog juicer and the mono frog juicer be used as an auto reverser for a return loop as well. 2) could several (4) be hooked up to a double cross over to ease or solve the wiring problems. I have seen some of the wiring solutions that call for an auto reverser. Could the "juicer " be used in this regard? Again sorry if this has already been covered. Jim Lowery |
Author: | Chesticus [ Thu Jul 29, 2010 9:45 pm ] |
Post subject: | Re: question about the "hex and single juicer?" |
OK I read on the web site that it IS capable of dealing with the complications associated with a "double crossover." I think this will make my #8 double crossover wiring much easier. |
Author: | Chesticus [ Thu Jul 29, 2010 9:49 pm ] |
Post subject: | Re: question about the "hex and single juicer?" |
OK last question on this matter. If my calculations are correct I can use the hex frog juicer to control the 4 isolated sections of a double crossover AND the last 2 wires to control the reversing loop on my lower staging. Does it matter how long the wires are? Jim Lowery |
Author: | Airwolf Crazy [ Thu Sep 09, 2010 7:33 am ] |
Post subject: | Re: question about the "hex and single juicer?" |
Greetings, I remember reading or hearing on a vid. that the juicer can control a frog up to 3' away without any noticable effects. The trouble is that I cannot find that documentation. I have a Hex juicer and the furtherest turnout it controls is just about at the 3' mark. I have not noticed any trouble with it. I have a switch I was going to have to control from a further point but with the new single juicers it is now not a problem. Christopher |
Author: | Chesticus [ Sun Apr 10, 2011 2:35 am ] |
Post subject: | Re: question about the "hex and single juicer?" |
I went to the actual site for the frog juicer, and there is documentation there that tells a person exactly how to wire for a double cross over. Even though I was skeptical, I did as the site said and the cross over is working perfectly now. thanks Jim Lowery |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |