Fast Tracks

Model Railroading Discussion Forums

Return To The Fast Tracks Website

The Fast Tracks discussion forums have been closed. Click Here for more information.

It is currently Tue Dec 03, 2024 1:56 pm

All times are UTC - 5 hours [ DST ]




Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 
Author Message
PostPosted: Tue Apr 28, 2009 9:23 am 
Offline

Joined: Fri Feb 13, 2009 9:00 am
Posts: 11
Fellow Turnout builders. I have an alternative way to create the pivot points on a Stub bridal rail and I'm also using this on my HOn3 code 55 3-way turnout.

In the video, I move the HOn3 code 55 bridal rail 2-1/2" side to side and PC board run straight.

http://www.cctrains.com/BridalRailPivot.wmv

Here how I made it....
I mark the PC board where the rails and pivot pins will be and remove the copper cladding. Then I file a notch on the inside flange flush to the rail web in the center of the PC board, drill a hole in the center of the notch. Take a brass pin, not a brad, and feed the pin from the bottom of the PC board. Take a dremel cut off saw and cut the pin leaving only about 1/16" showing. Without using flux, solder the pin to the rail. If you have problems with the pins falling out, dip the pin in some Pli-Bond and when your done with the turnout, take a old tooth brush and scrub the bottom of the PC board using lacquer thinner and it will dissolve the glue. Make sure you gap the bottom of the PC board between the pins, otherwise you will create a short.

Glen Thomas
Cream City Trains
http://www.cctrains.com


Top
 Profile  
 
Display posts from previous:  Sort by  
Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group