Fast Tracks

Model Railroading Discussion Forums

Return To The Fast Tracks Website

The Fast Tracks discussion forums have been closed. Click Here for more information.

It is currently Fri Oct 30, 2020 8:31 pm

All times are UTC - 5 hours [ DST ]




Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 4 posts ] 
Author Message
PostPosted: Fri Jun 26, 2015 9:39 pm 
Offline

Joined: Thu Jun 11, 2015 8:29 pm
Posts: 1
I am new to this business of making my own turnouts. All is going well, with each turnout better than the last.

I am having one problem I cannot solve - when I paint the PC tie that lies under the moving part of the point rails, the moving point rails scrapes the paint off the top of the tie (picture attached). The paint used is PolyScale.

Anyone have any suggestions? Also - Tim's videos mention a video on painting and finishing a turnout, but I can't find it. Any pointers?

Thanks,
Bob


Attachments:
paint.jpg
paint.jpg [ 81.63 KiB | Viewed 3285 times ]
Top
 Profile  
 
PostPosted: Tue Jun 30, 2015 3:35 pm 
Offline

Joined: Thu Feb 23, 2006 4:51 pm
Posts: 84
Hello Bob,

You could try the weathering solution marketed by Micro Engineering for weathering rail. It won't be a perfect solution but may diminish the bold copper look.

_________________
- Terry -
Customer Service - Fast Tracks HobbyWorks Inc.
service@fast-tracks.net


Top
 Profile  
 
PostPosted: Thu Dec 10, 2015 1:24 am 
Offline

Joined: Wed Nov 25, 2015 4:55 pm
Posts: 4
Since that copper tie location is for fixed points, you could try leaving it out and substituting a wood tie in that location. It looks like your wood ties are unaffected by the points movement.


Top
 Profile  
 
PostPosted: Fri Dec 11, 2015 3:53 pm 
Offline

Joined: Sat Aug 12, 2006 7:04 pm
Posts: 45
Another solution that you could try if the turnout has not been installed would be to use your soldering irons to loosen that tie and push it down then refill the solder joint and hold it in the down position while the solder cools. Repeat on the other rail, then repeat once more on both rails to release any twisting tension that might have built up. This will allow that tie to drop down a couple thousandths of an inch which should allow the rail to clear the painted area of the tie. If it is installed and not yet ballasted the same process should also work.


Top
 Profile  
 
Display posts from previous:  Sort by  
Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group