Fast Tracks
http://fast-tracks.net/forums/

Struggles with stub switches
http://fast-tracks.net/forums/viewtopic.php?f=4&t=1236
Page 1 of 1

Author:  Andy Anderson [ Fri Nov 23, 2012 10:36 pm ]
Post subject:  Struggles with stub switches

Has anyone had problems making stub switches with the jigs?

Seems that the turnout rails are at too sharp an angle for the bridle rails to bend to the correct angle.

Author:  sambear [ Sat Jan 05, 2013 11:47 pm ]
Post subject:  Re: Struggles with stub switches

I built stub switches on the #8 crossover. They worked, but it was hard to make sure they were hitting the spot. I think it better to use stub switches on longer turnouts, such as #10 or higher.

Author:  M1Garandman [ Mon Jan 07, 2013 1:33 am ]
Post subject:  Re: Struggles with stub switches

I'm new to this, I will start building Stub Switches as soon as I master "regular" switches. I need to make them #5, so would it help if the bridle rails were as long as possible?

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/