|Exact position of the "Kink" in the stock rail?
|Page 1 of 1|
|Author:||Blind Bruce [ Wed Jun 20, 2012 8:30 pm ]|
|Post subject:||Exact position of the "Kink" in the stock rail?|
The video is a bit vague on the position of the kink just behind the points of the diverging stock rail.
Since we have already milled off the base of the rail with the stockaid, the point just behind the points will tend to bend at the place the points meet the rail. Placing a kink there might deform the stock rail such as to impede proper fitting of the point rail.
Is the kinks actual position that close to the end of the point rail?
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group